|author||Sam Ravnborg <firstname.lastname@example.org>||2005-07-11 21:13:56 -0700|
|committer||David S. Miller <email@example.com>||2005-07-11 21:13:56 -0700|
[NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols. With this change net/Kconfig now starts to become readable and serve as a good basis for further re-structuring. The menu structure is left almost intact, except that indention is fixed in most cases. Most visible are the INET changes where several "depends on INET" are replaced with a single ifdef INET / endif pair. Several new files were created to accomplish this change - they are small but serve the purpose that config options are now distributed out where they belongs. Signed-off-by: Sam Ravnborg <firstname.lastname@example.org> Signed-off-by: David S. Miller <email@example.com>
Diffstat (limited to 'net/lapb')
1 files changed, 22 insertions, 0 deletions
diff --git a/net/lapb/Kconfig b/net/lapb/Kconfig
new file mode 100644
@@ -0,0 +1,22 @@
+# LAPB Data Link Drive
+ tristate "LAPB Data Link Driver (EXPERIMENTAL)"
+ depends on EXPERIMENTAL
+ Link Access Procedure, Balanced (LAPB) is the data link layer (i.e.
+ the lower) part of the X.25 protocol. It offers a reliable
+ connection service to exchange data frames with one other host, and
+ it is used to transport higher level protocols (mostly X.25 Packet
+ Layer, the higher part of X.25, but others are possible as well).
+ Usually, LAPB is used with specialized X.21 network cards, but Linux
+ currently supports LAPB only over Ethernet connections. If you want
+ to use LAPB connections over Ethernet, say Y here and to "LAPB over
+ Ethernet driver" below. Read
+ <file:Documentation/networking/lapb-module.txt> for technical
+ To compile this driver as a module, choose M here: the
+ module will be called lapb. If unsure, say N.