aboutsummaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--Documentation/networking/bonding.txt63
-rw-r--r--drivers/net/bonding/bond_3ad.c14
-rw-r--r--drivers/net/bonding/bond_main.c10
-rw-r--r--drivers/net/bonding/bond_options.c26
-rw-r--r--drivers/net/bonding/bond_sysfs.c15
-rw-r--r--include/net/bond_options.h1
-rw-r--r--include/net/bonding.h1
7 files changed, 123 insertions, 7 deletions
diff --git a/Documentation/networking/bonding.txt b/Documentation/networking/bonding.txt
index 2c197b68baf0..334b49ef02d1 100644
--- a/Documentation/networking/bonding.txt
+++ b/Documentation/networking/bonding.txt
@@ -51,6 +51,7 @@ Table of Contents
3.4 Configuring Bonding Manually via Sysfs
3.5 Configuration with Interfaces Support
3.6 Overriding Configuration for Special Cases
+3.7 Configuring LACP for 802.3ad mode in a more secure way
4. Querying Bonding Configuration
4.1 Bonding Configuration
@@ -241,6 +242,21 @@ ad_select
This option was added in bonding version 3.4.0.
+ad_user_port_key
+
+ In an AD system, the port-key has three parts as shown below -
+
+ Bits Use
+ 00 Duplex
+ 01-05 Speed
+ 06-15 User-defined
+
+ This defines the upper 10 bits of the port key. The values can be
+ from 0 - 1023. If not given, the system defaults to 0.
+
+ This parameter has effect only in 802.3ad mode and is available through
+ SysFs interface.
+
all_slaves_active
Specifies that duplicate frames (received on inactive ports) should be
@@ -1643,6 +1659,53 @@ output port selection.
This feature first appeared in bonding driver version 3.7.0 and support for
output slave selection was limited to round-robin and active-backup modes.
+3.7 Configuring LACP for 802.3ad mode in a more secure way
+----------------------------------------------------------
+
+When using 802.3ad bonding mode, the Actor (host) and Partner (switch)
+exchange LACPDUs. These LACPDUs cannot be sniffed, because they are
+destined to link local mac addresses (which switches/bridges are not
+supposed to forward). However, most of the values are easily predictable
+or are simply the machine's MAC address (which is trivially known to all
+other hosts in the same L2). This implies that other machines in the L2
+domain can spoof LACPDU packets from other hosts to the switch and potentially
+cause mayhem by joining (from the point of view of the switch) another
+machine's aggregate, thus receiving a portion of that hosts incoming
+traffic and / or spoofing traffic from that machine themselves (potentially
+even successfully terminating some portion of flows). Though this is not
+a likely scenario, one could avoid this possibility by simply configuring
+few bonding parameters:
+
+ (a) ad_actor_system : You can set a random mac-address that can be used for
+ these LACPDU exchanges. The value can not be either NULL or Multicast.
+ Also it's preferable to set the local-admin bit. Following shell code
+ generates a random mac-address as described above.
+
+ # sys_mac_addr=$(printf '%02x:%02x:%02x:%02x:%02x:%02x' \
+ $(( (RANDOM & 0xFE) | 0x02 )) \
+ $(( RANDOM & 0xFF )) \
+ $(( RANDOM & 0xFF )) \
+ $(( RANDOM & 0xFF )) \
+ $(( RANDOM & 0xFF )) \
+ $(( RANDOM & 0xFF )))
+ # echo $sys_mac_addr > /sys/class/net/bond0/bonding/ad_actor_system
+
+ (b) ad_actor_sys_prio : Randomize the system priority. The default value
+ is 65535, but system can take the value from 1 - 65535. Following shell
+ code generates random priority and sets it.
+
+ # sys_prio=$(( 1 + RANDOM + RANDOM ))
+ # echo $sys_prio > /sys/class/net/bond0/bonding/ad_actor_sys_prio
+
+ (c) ad_user_port_key : Use the user portion of the port-key. The default
+ keeps this empty. These are the upper 10 bits of the port-key and value
+ ranges from 0 - 1023. Following shell code generates these 10 bits and
+ sets it.
+
+ # usr_port_key=$(( RANDOM & 0x3FF ))
+ # echo $usr_port_key > /sys/class/net/bond0/bonding/ad_user_port_key
+
+
4 Querying Bonding Configuration
=================================
diff --git a/drivers/net/bonding/bond_3ad.c b/drivers/net/bonding/bond_3ad.c
index 012f7bc22d91..7fde4d5c2b28 100644
--- a/drivers/net/bonding/bond_3ad.c
+++ b/drivers/net/bonding/bond_3ad.c
@@ -75,10 +75,10 @@
/* Port Key definitions
* key is determined according to the link speed, duplex and
* user key (which is yet not supported)
- * --------------------------------------------------------------
- * Port key : | User key | Speed | Duplex |
- * --------------------------------------------------------------
- * 16 6 1 0
+ * --------------------------------------------------------------
+ * Port key | User key (10 bits) | Speed (5 bits) | Duplex|
+ * --------------------------------------------------------------
+ * |15 6|5 1|0
*/
#define AD_DUPLEX_KEY_MASKS 0x1
#define AD_SPEED_KEY_MASKS 0x3E
@@ -1951,10 +1951,10 @@ void bond_3ad_bind_slave(struct slave *slave)
port->slave = slave;
port->actor_port_number = SLAVE_AD_INFO(slave)->id;
- /* key is determined according to the link speed, duplex and user key(which
- * is yet not supported)
+ /* key is determined according to the link speed, duplex and
+ * user key
*/
- port->actor_admin_port_key = 0;
+ port->actor_admin_port_key = bond->params.ad_user_port_key << 6;
port->actor_admin_port_key |= __get_duplex(port);
port->actor_admin_port_key |= (__get_link_speed(port) << 1);
port->actor_oper_port_key = port->actor_admin_port_key;
diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
index a4e2f27ef683..2ee13be7551b 100644
--- a/drivers/net/bonding/bond_main.c
+++ b/drivers/net/bonding/bond_main.c
@@ -4141,6 +4141,7 @@ static int bond_check_params(struct bond_params *params)
const struct bond_opt_value *valptr;
int arp_all_targets_value;
u16 ad_actor_sys_prio = 0;
+ u16 ad_user_port_key = 0;
/* Convert string parameters. */
if (mode) {
@@ -4445,6 +4446,14 @@ static int bond_check_params(struct bond_params *params)
}
ad_actor_sys_prio = valptr->value;
+ valptr = bond_opt_parse(bond_opt_get(BOND_OPT_AD_USER_PORT_KEY),
+ &newval);
+ if (!valptr) {
+ pr_err("Error: No ad_user_port_key default value");
+ return -EINVAL;
+ }
+ ad_user_port_key = valptr->value;
+
if (lp_interval == 0) {
pr_warn("Warning: ip_interval must be between 1 and %d, so it was reset to %d\n",
INT_MAX, BOND_ALB_DEFAULT_LP_INTERVAL);
@@ -4475,6 +4484,7 @@ static int bond_check_params(struct bond_params *params)
params->tlb_dynamic_lb = 1; /* Default value */
params->ad_actor_sys_prio = ad_actor_sys_prio;
eth_zero_addr(params->ad_actor_system);
+ params->ad_user_port_key = ad_user_port_key;
if (packets_per_slave > 0) {
params->reciprocal_packets_per_slave =
reciprocal_value(packets_per_slave);
diff --git a/drivers/net/bonding/bond_options.c b/drivers/net/bonding/bond_options.c
index cdcef217ac84..c85da05721e6 100644
--- a/drivers/net/bonding/bond_options.c
+++ b/drivers/net/bonding/bond_options.c
@@ -74,6 +74,8 @@ static int bond_option_ad_actor_sys_prio_set(struct bonding *bond,
const struct bond_opt_value *newval);
static int bond_option_ad_actor_system_set(struct bonding *bond,
const struct bond_opt_value *newval);
+static int bond_option_ad_user_port_key_set(struct bonding *bond,
+ const struct bond_opt_value *newval);
static const struct bond_opt_value bond_mode_tbl[] = {
@@ -196,6 +198,12 @@ static const struct bond_opt_value bond_ad_actor_sys_prio_tbl[] = {
{ NULL, -1, 0},
};
+static const struct bond_opt_value bond_ad_user_port_key_tbl[] = {
+ { "minval", 0, BOND_VALFLAG_MIN | BOND_VALFLAG_DEFAULT},
+ { "maxval", 1023, BOND_VALFLAG_MAX},
+ { NULL, -1, 0},
+};
+
static const struct bond_option bond_opts[BOND_OPT_LAST] = {
[BOND_OPT_MODE] = {
.id = BOND_OPT_MODE,
@@ -405,6 +413,14 @@ static const struct bond_option bond_opts[BOND_OPT_LAST] = {
.flags = BOND_OPTFLAG_RAWVAL | BOND_OPTFLAG_IFDOWN,
.set = bond_option_ad_actor_system_set,
},
+ [BOND_OPT_AD_USER_PORT_KEY] = {
+ .id = BOND_OPT_AD_USER_PORT_KEY,
+ .name = "ad_user_port_key",
+ .unsuppmodes = BOND_MODE_ALL_EX(BIT(BOND_MODE_8023AD)),
+ .flags = BOND_OPTFLAG_IFDOWN,
+ .values = bond_ad_user_port_key_tbl,
+ .set = bond_option_ad_user_port_key_set,
+ }
};
/* Searches for an option by name */
@@ -1402,3 +1418,13 @@ static int bond_option_ad_actor_system_set(struct bonding *bond,
ether_addr_copy(bond->params.ad_actor_system, macaddr);
return 0;
}
+
+static int bond_option_ad_user_port_key_set(struct bonding *bond,
+ const struct bond_opt_value *newval)
+{
+ netdev_info(bond->dev, "Setting ad_user_port_key to (%llu)\n",
+ newval->value);
+
+ bond->params.ad_user_port_key = newval->value;
+ return 0;
+}
diff --git a/drivers/net/bonding/bond_sysfs.c b/drivers/net/bonding/bond_sysfs.c
index 09fefa50d055..143a2abd1c1c 100644
--- a/drivers/net/bonding/bond_sysfs.c
+++ b/drivers/net/bonding/bond_sysfs.c
@@ -721,6 +721,20 @@ static ssize_t bonding_show_ad_actor_system(struct device *d,
static DEVICE_ATTR(ad_actor_system, S_IRUGO | S_IWUSR,
bonding_show_ad_actor_system, bonding_sysfs_store_option);
+static ssize_t bonding_show_ad_user_port_key(struct device *d,
+ struct device_attribute *attr,
+ char *buf)
+{
+ struct bonding *bond = to_bond(d);
+
+ if (BOND_MODE(bond) == BOND_MODE_8023AD)
+ return sprintf(buf, "%hu\n", bond->params.ad_user_port_key);
+
+ return 0;
+}
+static DEVICE_ATTR(ad_user_port_key, S_IRUGO | S_IWUSR,
+ bonding_show_ad_user_port_key, bonding_sysfs_store_option);
+
static struct attribute *per_bond_attrs[] = {
&dev_attr_slaves.attr,
&dev_attr_mode.attr,
@@ -756,6 +770,7 @@ static struct attribute *per_bond_attrs[] = {
&dev_attr_tlb_dynamic_lb.attr,
&dev_attr_ad_actor_sys_prio.attr,
&dev_attr_ad_actor_system.attr,
+ &dev_attr_ad_user_port_key.attr,
NULL,
};
diff --git a/include/net/bond_options.h b/include/net/bond_options.h
index eeeefa1d3cd8..c28aca25320e 100644
--- a/include/net/bond_options.h
+++ b/include/net/bond_options.h
@@ -65,6 +65,7 @@ enum {
BOND_OPT_TLB_DYNAMIC_LB,
BOND_OPT_AD_ACTOR_SYS_PRIO,
BOND_OPT_AD_ACTOR_SYSTEM,
+ BOND_OPT_AD_USER_PORT_KEY,
BOND_OPT_LAST
};
diff --git a/include/net/bonding.h b/include/net/bonding.h
index 650f38693956..20defc0353d1 100644
--- a/include/net/bonding.h
+++ b/include/net/bonding.h
@@ -137,6 +137,7 @@ struct bond_params {
int tlb_dynamic_lb;
struct reciprocal_value reciprocal_packets_per_slave;
u16 ad_actor_sys_prio;
+ u16 ad_user_port_key;
u8 ad_actor_system[ETH_ALEN];
};

Privacy Policy