|author||Madhusudhan Chikkature <firstname.lastname@example.org>||2008-11-12 13:27:12 -0800|
|committer||Linus Torvalds <email@example.com>||2008-11-12 17:17:18 -0800|
hdq: documentation for OMAP HDQ
Add a brief document about omap2430/3430 HDQ/1-wire driver. Signed-off-by: Madhusudhan Chikkature<firstname.lastname@example.org> Acked-by: Evgeniy Polyakov <email@example.com> Signed-off-by: Andrew Morton <firstname.lastname@example.org> Signed-off-by: Linus Torvalds <email@example.com>
Diffstat (limited to 'Documentation/w1')
1 files changed, 46 insertions, 0 deletions
diff --git a/Documentation/w1/masters/omap-hdq b/Documentation/w1/masters/omap-hdq
new file mode 100644
@@ -0,0 +1,46 @@
+Kernel driver for omap HDQ/1-wire module.
+ HDQ/1-wire controller on the TI OMAP 2430/3430 platforms.
+A useful link about HDQ basics:
+The HDQ/1-Wire module of TI OMAP2430/3430 platforms implement the hardware
+protocol of the master functions of the Benchmark HDQ and the Dallas
+Semiconductor 1-Wire protocols. These protocols use a single wire for
+communication between the master (HDQ/1-Wire controller) and the slave
+(HDQ/1-Wire external compliant device).
+A typical application of the HDQ/1-Wire module is the communication with battery
+monitor (gas gauge) integrated circuits.
+The controller supports operation in both HDQ and 1-wire mode. The essential
+difference between the HDQ and 1-wire mode is how the slave device responds to
+initialization pulse.In HDQ mode, the firmware does not require the host to
+create an initialization pulse to the slave.However, the slave can be reset by
+using an initialization pulse (also referred to as a break pulse).The slave
+does not respond with a presence pulse as it does in the 1-Wire protocol.
+The driver (drivers/w1/masters/omap_hdq.c) supports the HDQ mode of the
+controller. In this mode, as we can not read the ID which obeys the W1
+spec(family:id:crc), a module parameter can be passed to the driver which will
+be used to calculate the CRC and pass back an appropriate slave ID to the W1
+By default the master driver and the BQ slave i/f
+driver(drivers/w1/slaves/w1_bq27000.c) sets the ID to 1.
+Please note to load both the modules with a different ID if required, but note
+that the ID used should be same for both master and slave driver loading.
+insmod omap_hdq.ko W1_ID=2
+inamod w1_bq27000.ko F_ID=2