path: root/Documentation/serial/computone.txt
diff options
Diffstat (limited to 'Documentation/serial/computone.txt')
1 files changed, 4 insertions, 4 deletions
diff --git a/Documentation/serial/computone.txt b/Documentation/serial/computone.txt
index 39ddcdbeeb85..a6a1158ea2ba 100644
--- a/Documentation/serial/computone.txt
+++ b/Documentation/serial/computone.txt
@@ -49,7 +49,7 @@ Hardware - If you have an ISA card, find a free interrupt and io port.
Note the hardware address from the Computone ISA cards installed into
the system. These are required for editing ip2.c or editing
- /etc/modprobe.conf, or for specification on the modprobe
+ /etc/modprobe.d/*.conf, or for specification on the modprobe
command line.
Note that the /etc/modules.conf should be used for older (pre-2.6)
@@ -66,7 +66,7 @@ b) Run "make config" or "make menuconfig" or "make xconfig"
c) Set address on ISA cards then:
edit /usr/src/linux/drivers/char/ip2.c if needed
- edit /etc/modprobe.conf if needed (module).
+ edit config file in /etc/modprobe.d/ if needed (module).
or both to match this setting.
d) Run "make modules"
e) Run "make modules_install"
@@ -153,11 +153,11 @@ the irqs are not specified the driver uses the default in ip2.c (which
selects polled mode). If no base addresses are specified the defaults in
ip2.c are used. If you are autoloading the driver module with kerneld or
kmod the base addresses and interrupt number must also be set in ip2.c
-and recompile or just insert and options line in /etc/modprobe.conf or both.
+and recompile or just insert and options line in /etc/modprobe.d/*.conf or both.
The options line is equivalent to the command line and takes precedence over
what is in ip2.c.
-/etc/modprobe.conf sample:
+config sample to put /etc/modprobe.d/*.conf:
options ip2 io=1,0x328 irq=1,10
alias char-major-71 ip2
alias char-major-72 ip2

Privacy Policy