aboutsummaryrefslogtreecommitdiffstats
path: root/drivers/thermal/imx_thermal.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/thermal/imx_thermal.c')
-rw-r--r--drivers/thermal/imx_thermal.c20
1 files changed, 20 insertions, 0 deletions
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
index 77a962f1837b..deab7baeeb72 100644
--- a/drivers/thermal/imx_thermal.c
+++ b/drivers/thermal/imx_thermal.c
@@ -7,6 +7,7 @@
*
*/
+#include <linux/clk.h>
#include <linux/cpu_cooling.h>
#include <linux/cpufreq.h>
#include <linux/delay.h>
@@ -73,6 +74,7 @@ struct imx_thermal_data {
unsigned long last_temp;
bool irq_enabled;
int irq;
+ struct clk *thermal_clk;
};
static void imx_set_alarm_temp(struct imx_thermal_data *data,
@@ -457,6 +459,22 @@ static int imx_thermal_probe(struct platform_device *pdev)
return ret;
}
+ data->thermal_clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(data->thermal_clk)) {
+ dev_warn(&pdev->dev, "failed to get thermal clk!\n");
+ } else {
+ /*
+ * Thermal sensor needs clk on to get correct value, normally
+ * we should enable its clk before taking measurement and disable
+ * clk after measurement is done, but if alarm function is enabled,
+ * hardware will auto measure the temperature periodically, so we
+ * need to keep the clk always on for alarm function.
+ */
+ ret = clk_prepare_enable(data->thermal_clk);
+ if (ret)
+ dev_warn(&pdev->dev, "failed to enable thermal clk: %d\n", ret);
+ }
+
/* Enable measurements at ~ 10 Hz */
regmap_write(map, TEMPSENSE1 + REG_CLR, TEMPSENSE1_MEASURE_FREQ);
measure_freq = DIV_ROUND_UP(32768, 10); /* 10 Hz */
@@ -478,6 +496,8 @@ static int imx_thermal_remove(struct platform_device *pdev)
/* Disable measurements */
regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_POWER_DOWN);
+ if (!IS_ERR(data->thermal_clk))
+ clk_disable_unprepare(data->thermal_clk);
thermal_zone_device_unregister(data->tz);
cpufreq_cooling_unregister(data->cdev);

Privacy Policy